Repair Range:plexiglass, acrylic PP, PC, PE, ABS and various types of other materials headlights
16 bottles one box
Headlight repair kit
10 sets one box
Matching repair headlamp tools:
The procedure of machine polishing is the same as manual polishing , it can be polished with 180# first when the crack is serious ,In the case of yellowish and peeling,it can be directly use 240 # for polishing, after that you can use 320 #, and then use 500 # and 800 # sandpaper, bear in mind that 800 # must use manual polishing, after used 800 # sandpaper it can be repairde,the same effect can be achieved with 1200 # sandpaper, remember that do not use # 1500 or # 2000# polishing again.When using grinding machine polish the headlamps, pouring water and polishing must be done at the same time. remember, press hard against the grinding machine to make sure the machine does not operate too quickly, the edge of the headlamp to camber grinding machine, special attention must be paid when the worker polishing the headlamp corner on the top of the car, must camber grinding machine, with the edge of the Angle of the grinding machine to grind the headlamp Angle!
Pay attention not to wear car paint, when polishing the headlamp with a grinding machine each piece of sandpaper must be evenly polished without omission. the function of the 320 # sandpaper is to polish the mark that 240 # sandpaper left, if 320 # sandpaper cant get rid of the mark , it is even harder for 500 #sandpaper, so every sand paper can't miss, and so on. The keypoint of the headlamp repair is sanding!! If the result is not good, the problem is that the lack of polishment.
After polishing, use toilet paper to clean up the moisture of the headlamp, must wipe clean without watermark, Y'd better work in an environment without wind, in case the material is blown away by the wind.
Firstly, pour into 80-100 mL headlamp repair liquid, it can be recycled, but must ensure adequate dosage, in case the gas uneven and atomization dry glass, imported rawmaterials,switching on the equipment to heat material,about three minutes,a gas will come out from the gas pipeline, pay attention to the outlet, the outlet is one centimeter from the lamb, start from edge of the light,the area where the outlet is exposed will become transparent and smooth, keep uniform speed, please remember: if bright, do not need to repeatedly fumigation, if there is a bit deep scratches, handle it a little slower, scratches will besmoked away by material!
After the repair is complete, please power off immediately, wait for two minutes, open the lid and recycle the remaining ingredients in the cup.